Make sure the LEDs on both buds are solid red \u2013 that means they are both charging<\/p><\/div>\n
You can <\/span>leave them charging for a minimum of ten minutes<\/b> if you are in a hurry, giving you two hours of playtime.<\/span><\/p>\nBut it is preferable that you are patient until the buds are fully charged, and <\/span>you will know they are charged when you see the red LEDs go off<\/b> when the buds are placed in the case.\u00a0<\/span><\/p>\nWhile at it, also <\/span>ensure that the charging case is adequately charged<\/b>. The LEDs on the case that turn on each time you open it communicate how much power the case has left. Each light represents a twenty-five percent battery level.\u00a0<\/span><\/p>\nTherefore, <\/span>if you notice that the case has less than fifty percent battery, charge it as you leave the buds inside also to charge<\/b>.\u00a0<\/span><\/p>\nOnce the buds are charged, take them out of the case and check whether they are now pairing with each other.\u00a0<\/span><\/p>\nYou will know this is happening if both buds flash blue when restarted.\u00a0<\/span><\/p>\nBoth buds flashing blue means the buds are pairing with each other<\/p><\/div>\n
After syncing, the left one will flash red-blue, indicating they are in pairing mode.\u00a0<\/span><\/p>\nLeft bud flashing red and blue \u2013 the earbuds are in pairing mode<\/p><\/div>\n
The buds will also play a tone once they connect. Below are steps on how you can restart the earbuds.<\/span><\/b><\/p>\nRestart the Earbuds<\/b><\/h2>\n
Another possible solution for pairing the buds when they are not connecting to each other is to <\/span>restart them<\/b>.\u00a0<\/span><\/p>\nYou can restart them through the following steps:<\/span><\/p>\n\n
\n- <\/i> Open the charging case, place both earbuds inside, and ensure the LEDs on the buds are glowing red steadily.\u00a0<\/span><\/li>\n
- <\/i> When the buds are correctly placed in the case, they power off. If they do not power off, close the case, then open it, and the LEDs should light red this time.\u00a0<\/span><\/li>\n
- <\/i> Next, take both earbuds from the case and observe the LED behavior.\u00a0<\/span><\/li>\n
- <\/i> The buds should flash blue, indicating they are synching, and once synched, you should hear a tone, and only the left earbuds LED remains flashing red and blue.\u00a0<\/span><\/li>\n
- <\/i> Another way to restart the buds is by touching and holding the touch area on both buds for six seconds<\/b>.\u00a0<\/span><\/li>\n
- <\/i> Once off, <\/span>power them back on by holding the touch area on both buds for four seconds<\/b>. The earbuds will then attempt to sync with each other.<\/span><\/li>\n<\/ul>\n<\/div>\n
Restart your Indy Evo earbuds by turning them off and then back on.<\/p><\/div>\n
If restarting the earbuds doesn\u2019t fix the problem, factory reset them.\u00a0<\/span><\/b><\/p>\nFactory Reset the Indy Evo Earbuds<\/b><\/h2>\n
A <\/span>factory reset will clear all pairing information<\/b> from the earbuds and allow them to establish a new connection with each other.\u00a0<\/span><\/p>\nHere is how to effectively factory reset the Skullcandy Indy Evo:<\/span><\/p>\n\n
\n- <\/i> Forget the earbuds from the source device<\/b> and <\/span>turn off Bluetooth on all devices near you<\/b>.<\/span><\/li>\n
- <\/i> Then manually <\/span>power off the buds<\/b> by holding the touch area for six seconds.<\/span><\/li>\n
- <\/i> Once they are powered off, hold the touch area for ten seconds<\/b> (use a timer to ensure it is not less than ten seconds). The earbuds will turn on and off.<\/span><\/li>\n<\/ul>\n
Press and hold touch panels on both buds for 10 seconds, while the earbuds are off. This will reset your Indy Evo.<\/p><\/div>\n
\n- <\/i> Once off, place them back in the case and ensure the LEDs on the buds flash red, then take them out.<\/span><\/li>\n
- <\/i> They will automatically power on, and both buds will start flashing blue as they sync.<\/span><\/li>\n
- <\/i> Once they have paired, the left bud will flash red-blue.<\/span><\/li>\n
- <\/i> You might have to repeat this process a few times since it does not always work the first time.<\/span><\/li>\n<\/ul>\n<\/div>\n<\/i><\/b><\/p>\n
Resetting Indy Evo \u2013 Quick Tutorial<\/i><\/b><\/p>\n<\/div>
HOW TO RESET : SKULLCANDY INDY FUEL True Wireless Earphones By Soundproofbros<\/div><\/div>
<\/div>